How to prevent contamination during the printing process of silver paste and carbon paste?
In the manufacturing of membrane switches and flexible circuits, cross-contamination of silver paste and carbon paste, or the intrusion of environmental contaminants, can directly lead to product short circuits, excessive sheet resistance, or poor adhesion. To effectively prevent contamination, a strict protection system needs to be established from four dimensions: personnel control, environmental purification, equipment maintenance, and process isolation.

I. Strict personnel and material control
Anti-pollution wearing standards: Operators must strictly follow the anti-pollution glove regulations. It is strictly prohibited to touch the substrate and slurry with bare hands to avoid fingerprint and grease contamination. When entering or leaving the workshop, dust rollers must be used to remove dust and foreign substances from cuffs and clothes.
Pre-treatment cleaning of substrates: Before printing, the substrates must be thoroughly cleaned. First, use compressed air to remove floating dust, then use a dust-free cloth dipped in 99% isopropyl alcohol (or alcohol) to gently wipe the surface in the same direction to prevent secondary pollution from static electricity.
Turnover protection: During the circulation and storage of semi-finished products after printing, they must be wrapped and placed with films to prevent dust and impurities from entering.
II. Control of Cleanliness in the Production Environment
High-grade Cleanroom: The printing of silver paste and other precision circuits should be carried out in a hundred-level clean room (with no more than 100 particles with a diameter of ≥ 0.5 micrometers per cubic meter of air), and sufficient FFU fan filtering units should be equipped for air recirculation.
Precise temperature and humidity regulation: The workshop temperature should be controlled at 20-30℃, and the relative humidity should be maintained between 40% and 70%. Low humidity (< 30%) can easily cause static electricity and accelerate the drying of ink in the mesh, resulting in clogged holes; high humidity can affect the drying speed.
Fixed-point dust collection: The printing machine should be equipped with a dedicated dust collection device to capture the fine dust before it spreads. This not only maintains an ultra-clean environment but also significantly reduces the residual dust rate, effectively reducing the problem of gate line breakage.
III. Equipment Maintenance and Specialized Use of Tools
Independent cleaning tools: For each process (especially the carbon paste and silver paste processes), separate cleaning tools must be used to strictly prevent cross-contamination.
Metal foreign matter adsorption: To address the potential metal foreign matter generated by the wear of the equipment guide rails, magnetic strips can be added at the guide rail positions for adsorption; at the same time, humidifiers and ion blowers should be added to ensure the printing surface is clean and free of static electricity.
Precision cleaning of screen plates: After the screen plates are used, they must be cleaned by ultrasonic waves and checked through the light box to ensure there are no residues in the mesh holes; the returned silver paste must be returned to the manufacturer for re-filtering (controlled at 0.5 μm size) before it can be used again.
IV. Physical Isolation of Process Parameters
Hybrid application strategy (silver-carbon overlay): In actual production, carbon paste's high covering property is often utilized to conduct a secondary coverage printing on the silver paste lines. This process not only reduces the cost of the main lines but also serves as a physical protective layer, effectively inhibiting silver migration.
Peelable blue adhesive protection: In specific areas where silver paste is printed, "peelable blue adhesive" can be added for treatment to effectively prevent dust contamination during the processing.
