Welcome to LuphiTouch®!
Today is 2026.11.05 , Thursday
Leave Your Message
News Categories
    Featured News

    Is it better to replace the broken film circuit directly or can it be repaired?

    2026-06-05

    Theoretically, faults in thin-film circuits can be repaired. However, in practical operation, it is strongly recommended to replace the faulty parts directly.
    Whether it is worth attempting to repair depends mainly on the location and number of the faults, as well as your maintenance purpose. Here are detailed evaluation suggestions:

    1.Why is "direct replacement" usually recommended?
    Low cost: The majority of regular membrane keypad components are extremely inexpensive. 
    High repair difficulty and prone to recurrence: The substrate of the membrane keypad is PET plastic, which is extremely intolerant to high temperatures and absolutely cannot be soldered with an electric soldering iron. Only conductive silver paint or conductive carbon pens can be used for manual outlining. Due to the continuous bending of the film during daily use, the silver lines that are manually repaired are prone to break again after being pressed dozens of times.
    Time-consuming and labor-intensive: Finding the break point, grinding the insulation layer, precisely outlining, waiting for curing, the entire process requires a lot of patience and the success rate is difficult to guarantee.

    machinery equipment (3).jpg

    2. Under what circumstances can "repair" be attempted?
    If you don't have a replacement part at hand, or the accessory has been discontinued and is unavailable for purchase, and the following conditions are met, you can attempt to repair:
    Optimal break point location: The short circuit occurs at the tail end of the film, at the root of the wiring line or in the flat edge area. These locations do not require significant bending and the repair life is relatively longer.
    Very few short circuits: Only 1 to 2 wiring lines are broken. If the internal wiring is like a spider web with extensive breaks, give up immediately as there is no repair value.
    Non-core buttons: The damage is to infrequently used function keys, rather than frequently used keys like Enter or Space.

    3. If you decide to repair, what are the correct operation procedures?
    If you decide to proceed, please make sure to follow the following steps:
    Precise location: Use the buzzer function of a multimeter to gradually check along the circuit, and find the exact point of breakage.
    Clean the wound: Use a utility knife tip or extremely fine sandpaper to gently scrape off the transparent insulating layer on both ends of the break point, revealing the underlying conductive silver paste or carbon powder layer (be sure not to scratch through the plastic substrate).
    Electrical connection: Use conductive silver paint pen (or conductive copper tape), draw a line slightly wider than the original circuit at the break point.
    Complete curing: It must be placed flat and left to stand still, waiting for the conductive silver paint to completely dry (usually it takes several hours) before conducting an electrical test.

    Summary: Unless it is a special case such as "unable to purchase the component" or "broken at the connector end", there is no need to waste time on repairing the broken film circuit. Simply spend 10-15 yuan to buy a brand-new membrane keypad of the same model and replace it. This is the most convenient and reliable option.