Is it easy to damage the membrane switch by using a hair dryer?
It is very easy to be damaged. It is strongly recommended not to use a hair dryer (especially the hot air setting) to dry the membrane switch.
The internal structure of the membrane switch is extremely precise and fragile. Using a hair dryer can easily cause the following irreversible physical damage:

1.High temperatures cause the internal structure to melt and deform (the most fatal).
Between the two conductive films on the upper and lower layers of the membrane switch, there is usually a very thin insulating isolation layer (mostly made of PET or PC materials). These plastic materials are very sensitive to high temperatures. The temperature of the hot air from the hair dryer is usually above 60°C to 100°C, which can easily cause the isolation layer to soften, deform, or even melt. Once the isolation layer melts, the upper and lower conductive contacts will permanently stick together, resulting in large-scale "bonding" or complete failure.
2. Thermal contraction and wrinkling of the substrate
The substrate of the membrane switch is prone to thermal expansion and contraction when heated unevenly. The localized high temperature from the hair dryer can cause the film substrate to shrink, wrinkle or develop irrecoverable folds. This not only damages the overall flatness of the film but also makes it impossible to align the positioning holes during installation, resulting in a poor button feel or even complete failure.
3. Accelerated detachment of conductive silver paste
The circuit of the membrane switch is printed on the substrate using conductive silver paste. High-temperature baking will accelerate the aging of the silver paste layer, making it brittle and even causing it to peel off from the substrate. Once the conductive layer detaches, the button will be completely disconnected and lose functionality.
4. The airflow blows the moisture deeper inside.
The strong wind pressure of the hair dryer not only fails to effectively remove the moisture from the film layer, but may also "push" the water droplets that were originally on the surface through the gaps into the deeper areas of the film, causing short circuits in areas that were not damaged originally.
The correct drying method:
If you accidentally spill liquid onto the membrane switch, please follow the steps below immediately:
Immediately cut off power: Unplug the power supply or remove the battery to prevent short circuits and damage to the motherboard.
Invert to drain water: Turn the device upside down to allow gravity to help the liquid flow out.
Absorb water on the surface: Use a paper towel or ultra-fine fabric to absorb the visible moisture on the surface.
Allow to air dry naturally: Place the device in a ventilated, dry, and room-temperature environment and leave it for at least 48 to 72 hours to allow the internal moisture to evaporate naturally. If drying is urgent, you can use the cold air setting of a hair dryer and keep a distance of at least 30 centimeters to blow from a distance, but the safest option is still to wait for it to naturally dry.
