Welcome to LuphiTouch®!
Today is 2026.11.05 , Thursday
Leave Your Message
News Categories
    Featured News

    What should be done if liquid gets into the membrane keypad?

    2026-06-05

    Once the membrane keypad gets wet, the most crucial principle is: immediately cut off the power supply and never attempt to test the key! Liquids (especially sugary beverages or those with salt content) will form an electrical path inside the film. At this point, powering on or pressing the key can easily cause the motherboard to short circuit and burn out, or even lead to irreversible electrochemical corrosion.
    Please follow the following emergency handling procedures:

    productive process (4).jpg

    Step 1: Emergency Power Cut and External Cleaning
    Immediate Power Cut: Unplug the power supply of the device. For laptops or devices with batteries, quickly remove the battery.
    Absorb Surface Liquids: Use paper towels or lint-free cloths to quickly absorb the liquid on the keyboard surface. Invert the device (in a "V" shape or with the keyboard facing down) and use gravity to allow the liquid to flow out to prevent further infiltration into the device's motherboard.


    Step 2: Disassembly and Deep Drying (Key Step)

    The membrane keypad is a multi-layer composite structure. Liquids can easily penetrate between the upper and lower layers of the films, and natural air drying is almost impossible to completely dry them out.
    Disassembling the membrane keypad: Completely remove the membrane keypad component from the device.
    Separating the film layers (depending on the situation): If the liquid inflow is large and the sealing glue at the edges of the films has not been completely sealed, it is recommended to carefully peel off the upper and lower layers of the films gently.
    Thorough drying: Place the separated films in a ventilated and dry place, or use a hair dryer with cold or slightly warm air (strictly prohibit using high temperature, otherwise the film will curl up and be ruined). It is recommended to leave them to stand for at least 24-48 hours to ensure that 100% of the internal moisture has evaporated.

    Step 3: Clean the residues (for non-pure water liquids)
    If the substance that enters is non-pure water liquids such as cola, coffee, or soup, after the moisture dries, sticky substances or salts will remain, causing the buttons to stick together or continuously corroding the circuits.
    Gentle wiping: Use a cotton swab dipped in a small amount of anhydrous alcohol (isopropyl alcohol) or a dedicated electronic contact cleaner to gently wipe the residues on the film contacts and the circuits.
    Be careful with the force: The conductive silver paste or carbon powder coating on the film surface is very fragile. When wiping, be sure not to apply excessive force, as it may cause the conductive layer to be completely wiped off.

    Step 4: Restoration and Testing
    Reattachment: After ensuring that the interior of the film is completely dry and free of foreign substances, precisely align and attach the upper and lower layers of the film.
    Multimeter Inspection: Before reconnecting the motherboard, it is advisable to use a multimeter to test the connectivity of the key buttons to ensure that there is no internal short circuit due to the liquid.
    Power-on Test: After confirming everything is correct, connect the power supply and perform a test by turning on the device.

    Cautionary note:
    Do not use WD-40 or ordinary rust removers: These products contain oily solvents that will dissolve the isolation gel layer inside the membrane keypad, causing the buttons to be completely damaged.
    Do not power on with water present: Even if there is just a single drop of water remaining between the contacts, when powered on, it will instantly cause electrochemical corrosion, breaking the originally intact circuit.